10mm Round Zip Wire Support Bracket

This hot dipped round faced galvanised steel zip wire cable bracket has been specifically designed for use in your 10mm zip wire installation, if you are using a support frame with a round wood crossbar at the receiving end.

10mm Round Zip Wire Support Bracket Specfication:

• Material: Hot dipped galvanised steel
• To fit round timber with a diameter of 140mm - 160mm
• TUV tested for use in commercial and domestic situations
• EN1176-1: 2008
• EN1176-4: 2008

Suitable for use with 10mm wire that has a thimble eye at one end.

It acts as the anchor point on the receiving end crossbar by fastening the thimble eye of your zip wire cable via the bolt.

It has been designed to be used with round timber that has a diameter of between 140mm - 160mm and has been TUV tested to meet and exceed European Safety Standards.

Please note:
Studding Rod or Fixing bolts are NOT included and are something you will need to buy from a good Hardware store.

Bolts to be inspected and retighten (if needed) at every inspection