Commercial 10mm Zip Wire Support Bracket

These hot dipped commercial zip wire support brackets have been specifically designed for use with your 10mm zip wire installation, if you are using a support frame with either a round or square wood crossbar at the receiving end.

Commercial Zip Wire Support Bracket Specfication:

• Material: Hot dipped galvanised steel
• To fit round timber with a diameter of 140mm - 160mm
• To fit square timber with a minimum size of 140mm
• TUV tested for use in commercial and domestic situations
• EN1176-1: 2008
• EN1176-4: 2008

Commercial Zip Wire Support Bracket Sizes:

• Round: 161 x140 x 70mm
• Square: 145 x 140 x 70mm

Suitable for use with 10mm wire that has a thimble eye at one end.

It acts as the anchor point on the receiving end crossbar by fastening the thimble eye of your zip wire cable via the bolt.

These commercial support brackets have been designed to be used with round timber that has a diameter of between 140mm - 160mm or square timber with a minimum size of 140mm. They have been TUV tested to meet and exceed European Safety Standards.

Please note:
Studding Rod or Fixing bolts are NOT included and are something you will need to buy from a good Hardware store.

Bolts to be inspected and retighten (if needed) at every inspection